Periodically on-off Mosquito repellents circuit.

-

 Periodically on-off Mosquito repellents circuit using IC LM 555

         Some of the mosquito repellents available in the market use a toxic liquid to generate poisonous vapours in order to repel mosquitoes out of the room. Due to the continuous release of poisonous vapours into the room, after midnight the natural balance of the air composition for good health reaches or exceeds the critical level. Mostly, these vapours attack the brain through lungs and exert an anaesthetic effect on mosquitoes as well as other living beings by small or greater percentage. Long exposure to these toxic vapours may cause neurological or related problems 

How to make Periodically on-off Mosquito repellents circuit mini Project



/./

How to make Periodically on-off Mosquito repellents circuit.

Electronics mini project using ic lm555.

Electronics mini project using Triac.

How to make Electronics mini project.

Mosquito repellents circuit Diagram.

Comments

Post a Comment

Featured Post

How to make door Alarm Circuit using scr

-
Image
 Door Alarm using SCR    SCR ( silicon controlled Rectifier) also called Thyristor is a  semiconductor controlled rectifier is a four layer solid state current controlling device. Components : 1. 1 × Low Power scr 2. 1 × 9v Battery 3. 1 × buzzer 4. 2 × Switches 5. 1 × 1k ohm resistor ( may be vary) Circuit Diagram : Door Alarm system using SCR Working : 1. Make circuit as per Circuit Diagram. 2. Place switch in on door in that way when door is open, switch is closed. 3. When Switch is closed a triggering pulse apply to gate and scr is turn on. Attention :   To turn off  buzzer place one more switch between positive terminal and scr anode. OR remove Battery    
Read more

Low Power Inverter : Electronics Mini projects

-
Image
 Low Power Inverter : 12DC into 230-250V AC     Here is a  simple low-power inverter that converts 12V DC Into 230-250V AC. It can be used to power very light loads like Window chargers and night lamps, or Simply give shock to keep the intruders away. The circuit is built around Just two ICs, namely, IC CD4047 and IC ULN2004.      IC CD4047 (IC1) is a monostable / astable multivibrator. It is wired in astable mode and produces symmetrical pulses of 50 to 400 Hz, which are Given to IC2 via resistors R1 and R2.    IC ULN2004 (IC2) is a popular 7-channel Darlington array IC. Here, The three Darlington stages are Paralleled to amplify the frequencies Received from IC1. The output of IC2 Is fed to transformer X1 via resistors R3 and R4.     Transformer X1 (9V-0-9V, 500mA Secondary) is an ordinary step-down Transformer that is used here for the reverse function, i.e., step up. That Means it produces a high voltage. Resistors R3 and R4 are used to limit The output current from the ULN
Read more